Changeset 4990 for lm-sensors/branches/lm-sensors-3.0.0/doc/fan-divisors

Timestamp:

10/25/07 11:59:05 (4 years ago)

Author:

khali

Message:

Use /etc/sensors3.conf as the default configuration file. If it can't
be found, fallback to /etc/sensors.conf. This allows for an old
libsensors and a new libsensors to be installed in parallel, and each
one has its own configuration file.

One important change here is that the default configuration file will
be installed as /etc/sensors3.conf by "make install".

Files:

• lm-sensors/branches/lm-sensors-3.0.0/doc/fan-divisors (modified) (2 diffs)

lm-sensors/branches/lm-sensors-3.0.0/doc/fan-divisors

@@ -48 +48 @@
 
 Put an entry "set fanN_div X" in the appropriate section of
-/etc/sensors.conf and run 'sensors -s'
+/etc/sensors3.conf and run 'sensors -s'
 (N is the number of the fan, and X is the divisor you want).
 
@@ -88 +88 @@
 As we learned above, you can _not_ fix this by changing
 the fan divisor. You must add entries into the appropriate
-section of /etc/sensors.conf:
+section of /etc/sensors3.conf:
 
         compute fanN  @/2,  2*@